Product Description
Clear MyVision Anti–Fog Coating creates a moisture–absorbing hydrophilic layer reducing droplet surface tension. This results in a thin and continous layer of water on the surface instead of tiny beaded water droplets i.e. fogging. This ‘flat’ layer improves visibility in all weathers and temperatures.
Directions
• Ensure surface is fully clean before application
• Apply a small amount of coating to a paper towel or dry cotton cloth and wipe lightly across surface to be treated
• Allow coating to dry
• Re-apply as and when needed to maintain fog-free condition
IMPORTANT: PLEASE REMEMBER THIS IS A COATING FOR INNER SURFACES OF VISORS, WINDSCREENS, GOGGLES ETC.
ENSURE COATING IS APPLIED TO CORRECT SURFACE.
1 review for Clear MyVision
Anti-Fog Coating 50ml
Only logged in customers who have purchased this product may leave a review.
“So some feedback on the new Clean MyVision products.
Anti fog – followed instructions and cleaned inside of visor then applied a small amount to tissue paper and applied to the areas outside my pinlock which usually steam up… No steaming. Also applied to my sun visor the same way and again, no fogging this morning.
Rain Repellant (Hydrophobic treatment for visor outer) – again followed instructions and applied as intended and nothing stuck to my visor at all this morning. Clean as a whistle even though I was riding on wet, dirty roads.
My verdict – whilst there are other products out there that do the same job, this stuff works exceptionally well, does what it says on the bottle and is a lot cheaper than its competitors on the market.”
Minty – EMBR